Scilogex DM1424 Hematocrit-Centrifuge - Manual (Page 10)

7
Figure 6-2 The main interface
Main interface is as figure 6-2. The speed is set to be 14000rpm, temperature of centrifugal chamber is
25℃, and the running time is 12 minutes. When speed symbol is rotating, this indicates the centrifuge is
running. If the rotation is faster, the speed is higher. Temperature of chamber is displayed and cannot be
controlled. Time symbol
displays the ratio of working to time setting. The total time setting is divided
into 10 sections.
7. Rotor Preparation
7.1 Prepare the samples
7.2 Inject the samples into tubes
z Do not exceed the actual capacity allowed in the user manual.
7.3 Keep the tubes balanced
z Although the centrifuge can accept sample balancing by eye, we recommend that you keep this
centrifuge in a well-balanced condition to extend its life expectancy.
z Never intentionally run the centrifuge under an unbalanced condition even though the allowable
imbalance is not exceeded.
7.4 Inspect the rotor
Check the rotor for corrosion or scratches before using.
CAUTION
z If any abnormality such as corrosion or scratches are found, stop using the rotor and contact our
service center.
z Only manufacturer’s rotors must be used with the unit.
CAUTION
z Do not overload samples into the centrifuge which will cause leaking.
14000 25
℃
12
min rpm