Cisco IP/TV 3400 Series - Manual (Page 91)

3-29
Cisco IP/TV 3400 Series Servers User Guide
OL-4467-01
Chapter 3 Installing the IP/TV Server
Installing Cisco IP/TV 3427 Broadcast Server Units
Step 2 Connect the other end of the network cable to a hub or switch in your network.
Step 3 For monitor connections, plug the monitor cable into the onboard video port on
the IP/TV Server back panel. (See
Figure 3-23 .)
Step 4 Connect the other end of the monitor cable to a monitor.
Step 5 Plug the keyboard and mouse cables to the keyboard port and mouse port,
respectively. (See
Figure 3-23 .)
Connecting Power and Booting the System
To connect power to your system, follow these steps:
Step 1 Review the information in the “Safety Guidelines” section on page 2-4 .
Step 2 Plug a power cord into each power cord receptacle on the back of the IP/TV
Server. (See
Figure 3-23 .)
1 Keyboard port 8 SCSI 1 connector
1. SCSI = Small Computer System Interface
2 Onboard video port 9 USB
2
2 (not supported
2. USB = Universal Serial Bus
3 Serial port 10 USB 1 (not supported)
4 Mouse port 11 ISMP 3
port (not supported)
3. ISMP = Integrated System Management Processor
5 PCI
4
slots 1 and 2 (Winnov Videum 1010 Plus
video capture cards)
4. PCI = Peripheral Component Interconnect
12 ISMP port (not supported)
6 PCI slots 3 (Winnov Videum 4400 AV video
capture card), 4, and 5 (Optibase MovieMaker
200S Networker video capture cards) 13 Ethernet 2
7 AC power receptacles 14 Ethernet 1