Connecting power and booting the system – Cisco IP/TV 3400 Series User Manual

Page 70

Chapter 3 Installing the IP/TV Server

Installing Cisco IP/TV 3425 and 3425A Server Units

3-8

Cisco IP/TV 3400 Series Servers User Guide

OL-4467-01

Connecting Power and Booting the System

To connect AC power to the IP/TV Server, follow these steps:

Step 1

Plug the AC power cord into the power cord receptacle on the back of the IP/TV
Server. (See

Step 2

Connect the other end of the power cord to a power source at your installation site.

Step 3

Power on the device.

The system should begin booting. Once the operating system boots, you are ready
to configure the IP/TV Server. (See

)

Figure 3-8

Cisco IP/TV 3425 and 3425A Servers—Rear View

33192

Power switch

Power receptacle