Compex Systems 802.11N - Manual (Page 37)

Station Parameters Settings
Fig 2.4 Basic Wireless Settings (Station/Station WDS)
This options below are only available in Station, Station WDS and Repeater WDS modes
unless otherwise stated.
Wireless Mode: Station
Remote AP-ESSID
This is the Service Set Identifier used by station to seek and connect to the access point
of same the SSID identifier.
Site Survey
Site Survey will search for the available wireless networks in range on all the supported
channels and will allow you to select one for association. In case the selected network
uses encryption, you’ll need to set security parameters in wireless security section. Click
Scan to re-scan the Access Points in range. Select the Access Point from the list and click
Close this window. Site Survey channel scan list can be modified using the Channel Scan
List control.
Rem ote AP – Lock to MAC
Enter the MAC address of the remote access point the device is connected to. This option
will make device only connect to this access point. This is important when connection is
Point-to-Point operation.
Remote AP - Preferred MAC
Enter the preferred MAC address of the access point you want device to connect when it
first startup. Up to max of 4 MAC addresses can be entered. Priority is from top to bottom.
In the event all preferred MAC addresses are not available, device will then pick the
matching SSID access point with the strongest signal.