Dell PowerEdge R210 II - Manual (Page 59)

Installing System Components 59
9 Enter the System Setup program and ensure that the hard drive’s
controller is enabled. See "Entering the System Setup Program" on
page 26.
10 Exit the System Setup program and reboot the system.
See the documentation that came with the hard drive for instructions on
installing any software required for drive operation.
11 Close the system. See "Closing the System" on page 51.
12 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Removing a 3.5-Inch Hard Drive From a Hard-Drive Carrier
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the hard-drive carrier. See Figure 5-7.
book.book Page 59 Friday, March 7, 2014 1:35 PM