Dell Precision 490 - Manual (Page 145)

Attachment failed to respond — See Drive Problems .
Bad command or file name — Ensure that you spelled the command correctly, put spaces in the proper place, and used the correct path
name.
Bad error-correction code (ECC) on disk read — See Drive Problems .
Controller has failed — See Drive Problems .
Data error — See Drive Problems .
Decreasing available memory — See Lockups and Software Problems .
Diskette drive 0 seek failure — See Drive Problems .
Diskette read failure — See Drive Problems .
Diskette subsystem reset failed — Run the Dell Diagnostics. See (see Dell Diagnostics ).
Diskette write protected — Slide the write-protect notch to the open position.
Drive not ready — Put a floppy disk in the drive.
Gate A20 failure — See Lockups and Software Problems .
Hard-disk configuration error —
Hard-disk controller failure —
Hard-disk drive failure —
Hard-disk drive failure —
See Drive Problems .
Insert bootable media — Insert a bootable floppy disk, CD, or other bootable media.
Invalid configuration information - please run SETUP program — Enter the system setup program (see System Setup ) and correct the
computer configuration information.
Keyboard failure — See Keyboard Problems .
Memory address line failure at address, read value expecting value — See Memory Problems .
Memory allocation error —
1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.
Memory data line failure at address, read value expecting value —
Memory double word logic failure at address, read value expecting value —