Dell XPS 210 - Manual (Page 70)

70
Removing and Installing Parts
Removing Memory
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 61.
2 Press out the securing clip at each end of the memory module connector.
3 Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the
connector.
Cards
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
Your Dell™ computer provides the following slots for PCI Express cards:
• One PCI Express x16 card slot
• One PCI Express x1 card slot
NOTE:
The slots for the PCI Express x16 and PCI Express x1 cards are half-height slots.
1 PCI Express x16 card 2 PCI Express x1 card
3 PCI Express x1 card slot 4 PCI Express x16 card slot
1
4
2
3