Dell XPS/Dimension XPS Gen 5 - Manual (Page 96)

96
Removing and Installing Parts
www
.dell.com | support.dell.com
4 Install the hard drive into the computer by gently sliding the drive into place until the tabs
securely click into position.
NOTE:
If you are installing a hard drive in the lower bay, place the drive in the bay so that the power
connector is on the left-hand side (opposite of the top hard drive)
.
5 Connect a power cable to the drive.
6 Connect the hard-drive cable to the drive and to the system board (see page 77).
7 Check all connectors to be certain that they are properly cabled and firmly seated.
NOTICE:
When replacing the hard-drive shroud, ensure that all the cables are properly routed.
8 Insert the bottom tabs of the shroud in to the holes on the drive cage and rotate the
shroud up.
9 Press in on the top tabs and lock them in to place.
10 Gently press on the shroud to ensure it is secure.
hard drive
hard-drive cable
power cable tabs (2)
system board connector
D8659bk0.book Page 96 Thursday, March 10, 2005 10:18 AM