Dell OptiPlex GX60 - Manual (Page 28)

Back to Contents Page
Chassis Intrusion Switch
Dell™ OptiPlex™ GX60 Systems User's Guide
Replacing the Chassis Intrusion Switch
Resetting the Chassis Intrusion Detector
Replacing the Chassis Intrusion Switch
1. Follow the procedures in " Before You Begin ."
2. Disconnect the chassis intrusion switch cable from the control panel on the front of the computer.
Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks may hold the cable in place inside the chassis.
3. Slide the chassis intrusion switch out of its slot, and remove the switch and its attached cable from the computer.
Small Form-Factor Computer
Small Desktop Computer
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions .