Cd/dvd drive, Removing a cd/dvd drive – Dell OptiPlex GX60 User Manual
Page 100

After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next
computer start-up:
ALERT! Cover was previously removed.
11.
Reset the chassis intrusion detector
by changing Chassis Intrusion to Enabled or Enabled- Silent.
12.
Verify that your computer works correctly by running the
Dell Diagnostics
.
CD/DVD Drive
1.
Follow the procedures in "
Before You Begin
."
2.
If you are installing a new CD/DVD drive rather than replacing a drive,
remove the front-panel inserts
Removing a CD/DVD Drive
1.
Disconnect the power, audio, and CD/DVD drive cables from the back of the drive.
2.
Disconnect the other end of the CD/DVD drive cable from the system board connector (IDE2).
3.
Press inward on the two tabs on the sides of the drive, and then slide the drive upward and remove it from the drive bay.
NOTE:
If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion
detector.
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1 power cable
2 audio cable
3 CD/DVD drive cable
4 IDE2 connector