Dell OptiPlex GX60 - Manual (Page 142)

Back to Contents Page
Drives
Dell™ OptiPlex™ GX60 Systems User's Guide
General Installation Guidelines
Hard Drive
Front-Panel Inserts
Floppy Drive
CD/DVD Drive
Your computer supports:
l Two hard drives
l Two floppy or optional Zip drives
l Two CD or DVD drives
General Installation Guidelines
Connect hard drives to the connector labeled "IDE1," and connect CD/DVD drives to the connector labeled "IDE2."
IDE Drive Addressing
When you connect two IDE devices to a single IDE interface cable and configure them for the cable select setting, the device attached to the last connector on
the interface cable is the master or boot device (drive 0), and the device attached to the middle connector on the interface cable is the slave device (drive 1).
See the drive documentation in your upgrade kit for information on configuring devices for the cable select setting.
Connecting Drive Cables
When you install a drive, you connect two cables—a DC power cable and a data cable—to the back of the drive and to the system board. Some drives may
also have an audio connector; one end of the audio cable will attach to the drive connector and the other will attach to the system board.
IDE Drive Connector
1 CD/DVD drive(s)
2 floppy drive(s)
3 hard drive(s)