Dell OptiPlex GX260 - Manual (Page 69)

1 blower 4 retention base
2 screws (2) 5 heat sink
3 lever
9. Lift the heat sink/blower assembly away from the microprocessor.
10. Remove the two screws on the blower to remove it from the heat sink.
NOTICE: Do not discard the blower. You will reuse it. If you are installing a microprocessor upgrade kit from Dell,
discard the original heat sink. If you are not installing a microprocessor upgrade kit from Dell, reuse the original heat
sink when you install your new microprocessor.
NOTICE: Be careful not to bend any of the pins when you remove the microprocessor. Bending the pins can
permanently damage the microprocessor.
11. Pull the release lever straight up until the microprocessor is released, and then remove the microprocessor from the
socket.
Microprocessor Removal