Dell OptiPlex GX260 - Manual (Page 60)

board.
6. Remove the computer stand , if it is attached.
7. If you are installing a new floppy drive rather than replacing a drive, remove the front-panel inserts.
8. Open the computer cover.
Removing a Floppy Drive
1. Disconnect the floppy-drive cable from the system board connector (DSKT).
2. Remove the power cable from the interposer board.
3. Disconnect the CD/DVD drive cable and the power cable from the CD/DVD drive.
4. Remove or raise the drive by pressing the green tabs on either side of the drive and lifting the drive up.
5. Remove the floppy-drive cable from the floppy drive.
a. Remove the interposer board from the floppy drive by pressing the tab and rotating the interposer board.
Removing the Interposer Board
1 floppy-drive cable
2 tab
3 interposer board
4 system board floppy-drive connector (DSKT)
b. To release the floppy-drive cable from the connector, slide the lever until it is fully extended, and then lift the
cable away.
Removing the Floppy-Drive Cable