Ieee 1394 device problems – Dell Dimension 8400 User Manual
Page 37
Solving Problems
37
IEEE 1394 Device Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located
in the Product Information Guide.
A
FILENAME
CANNOT
CONTAIN
ANY
OF
THE
FOLLOWING
CHARACTERS
: \ / : * ? “ < > | —
Do not
use these characters in filenames.
A
REQUIRED
. D L L
FILE
WAS
NOT
FOUND
—
The program that you are trying to open is missing an
essential file. To remove and then reinstall the program:
1
Click the Start button, click Control Panel, and then click Add or Remove Programs.
2
Select the program you want to remove.
3
Click the Change or Remove Program icon.
See the program documentation for installation instructions.
drive letter :\
IS
NOT
ACCESSIBLE
. T
HE
DEVICE
IS
NOT
READY
—
The drive cannot read the disk.
Insert a disk into the drive and try again.
I
NSERT
BOOTABLE
MEDIA
—
Insert a bootable floppy disk or CD.
N
ON
-
SYSTEM
DISK
ERROR
—
Remove the floppy disk from the drive and restart your computer.
N
OT
ENOUGH
MEMORY
OR
RESOURCES
. C
AND
TRY
AGAIN
—
Close all
windows and open the program that you want to use. In some cases, you might have to restart your
computer to restore computer resources. If so, run the program that you want to use first.
O
E
NSURE
THAT
THE
CABLE
FOR
THE
INSERTED
INTO
THE
DEVICE
AND
INTO
THE
CONNECTOR
ON
THE
E
NSURE
THAT
THE
I E E E 1 3 9 4
DEVICE
IS
RECOGNIZED
BY
W
INDOWS
—
1
Click the Start button and click Control Panel.
2
Click Printers and Other Hardware.
If your IEEE 1394 device is listed, Windows recognizes the device.