Dell Vostro 200 (Mid 2007) - Manual (Page 154)

154
Removing and Installing Parts
NOTICE:
When replacing the processor, do not touch any of the pins inside the
socket or allow any objects to fall on the pins in the socket.
1 Follow the procedures in "Before You Begin" on page 99.
2 Unpack the new processor, being careful not to touch the underside of the
processor.
NOTICE:
You must position the processor correctly in the socket to avoid
permanent damage to the processor and the computer when you turn on the
computer.
3 If the release lever on the socket is not fully extended, move it to that
position.
4 Orient the front and rear alignment-notches on the processor with the
front and rear alignment-notches on the socket.
5 Align the pin-1 corners of the processor and socket.
NOTICE:
To avoid damage, ensure that the processor aligns properly with the
socket, and do not use excessive force when you install the processor.
6 Place the processor in the socket and ensure that it is positioned correctly.
7 When the processor is fully seated in the socket, close the processor cover.
Ensure that the tab on the processor cover is positioned underneath the
center cover latch on the socket.
8 Pivot the socket release lever back toward the socket, and snap it into place
to secure the processor.