Dell Vostro 200 (Mid 2007) - Manual (Page 130)

130
Removing and Installing Parts
6 Connect the power and data cables to the drive.
7 Connect the data cable to the system board.
8 Slide the hard drive into the hard drive bay until it snaps in place.
9 Check all cables to be certain that they are properly connected and firmly
seated.
10 Replace the support bracket (see "Replacing the Support Bracket" on page 161).
11 Replace the computer cover (see "Replacing the Computer Cover" on
page 162).
NOTICE:
To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
12 Connect your computer and devices to electrical outlets, and then turn
them on.
13 See the documentation that came with the drive for instructions on
installing any software required for drive operation.
14 Check the system setup for drive configuration changes (see "Entering
System Setup" on page 170).
1 second hard drive (optional) 2 shoulder screws (4)
2
1