Dell Studio 1435 (Late 2008) - Manual (Page 10)

Back to Contents Page
Coin-Cell Battery
Dell Studio™ 1435 Service Manual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery
Removing the Coin-Cell Battery
1. Follow the procedures in Before You Begin .
2. Turn the computer over and remove the base cover (see Removing the Base Cover ).
3. Remove the center control cover (see Removing the Center Control Cover ).
4. Remove the keyboard (see Removing the Keyboard ").
5. Remove the palm rest (see Removing the Palm Rest ").
6. Disconnect the coin-cell battery cable from the connector on the system board.
7. Remove the coin-cell battery.
Replacing the Coin-Cell Battery
1. Replace the coin-cell battery and connect the coin-cell battery cable to the connector on the system board.
2. Replace the palm rest (see Replacing the Palm Rest ).
3. Replace the keyboard (see Replacing the Keyboard ).
4. Replace the center control cover (see Replacing the Center Control Cover ).
5. Replace the base cover (see Replacing the Base Cover ).
6. Slide the battery into the bay until it clicks into place.
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
1 coin-cell battery 2 coin-cell battery cable connector