beautypg.com

Error messages, Address mark not found, Alert! security override jumper is installed – Dell Precision R5500 (Early 2011) User Manual

Page 84: Attachment failed to respond, Bad command or file name, Bad error-correction code (ecc) on disk read, Controller has failed, Data error

background image

Error Messages

Address mark not found

Description

The BIOS found a faulty disk sector or could not find a particular disk sector.

Alert! Previous attempts at booting this system have failed at checkpoint [nnnn]. For help

in resolving this problem, please note this checkpoint and contact Dell Technical Support.

Description

The computer failed to complete the boot routine three consecutive times for the same error.
Contact Dell and report the checkpoint code (nnnn) to the support technician

Alert! Security override Jumper is installed.

Description

The MFG_MODE jumper has been set and AMT Management features are disabled until it is
removed.

Attachment failed to respond

Description

The floppy or hard drive controller cannot send data to the associated drive.

Bad command or file name

Description

Ensure that you have spelled the command correctly, put spaces in the proper place, and used
the correct pathname.

Bad error-correction code (ECC) on disk read

Description

The floppy or hard drive controller detected an uncorrectable read error.

Controller has failed

Description

The hard drive or the associated controller is defective.

Data error

Description

The floppy or hard drive cannot read the data. For the Windows operating system, run the
chkdsk utility to check the file structure of the floppy or hard drive. For any other operating
system, run the appropriate corresponding utility.

84