Processor, Installing the processor airflow shroud, Removing the processor – Dell XPS 710 User Manual
Page 61

4.
Lift the processor airflow shroud out of the computer, and then set it aside.
Installing the Processor Airflow Shroud
1.
.
2.
Remove the computer cover (see
).
3.
Align the hinge slots on the processor airflow shroud with the hinge guides on the system board.
4.
Gently rotate the processor airflow shroud towards the fan, and then tighten the two captive screws.
5.
6.
Connect your computer and devices to electrical outlets, and turn them on.
Processor
Removing the Processor
1.
.
2.
Remove the computer cover (see
).
3.
Disconnect the power cables from the POWER1 and POWER2 connectors (see
4.
Remove the airflow shroud (see
Removing the Processor Airflow Shroud
5.
Push down and out on the socket release lever.
1
processor airflow shroud
2
captive screws (2)
NOTICE:
The processor heat sink is attached to the processor airflow shroud. When you remove the airflow shroud, lay it upside down or on its side to
avoid damaging the heatsink thermal interface.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly could
damage your system board. For technical service, see
Dell Hardware Warranty Support Policy (U.S. Only)
.