Dell Precision 220 - Manual (Page 39)

RIMMs
To remove a Rambus in-line memory module (RIMM), perform the following steps.
1. Remove the computer cover .
2. Rotate the system power supply to allow you to access the RIMMs.
3. Press the securing clips outward simultaneously until the RIMM disengages and pops out slightly from the socket (see Figure 27 ).
Figure 27. RIMM Removal
To reinstall a RIMM, perform the following steps.
1. Locate the plastic securing clips at each end of the socket (see Figure 28 ).
2. Press the clips outward until they snap open.
3. Press the RIMM straight into the slot running down the center of the socket until the securing tabs snap into place around the ends of the
RIMM.
After you replace the computer cover and restart the system , run the Dell Diagnostics to verify that the RIMMs are operating properly.
Figure 28. RIMM Installation
PCIn PCI expansion-card connector
POWER_1 Main power input connector
POWER_2 3.3-V power input connector
PROC_0 Primary microprocessor connector
PROC_1 Secondary microprocessor connector
SER Serial port connectors
STANDBY Standby power LED
STR Suspend-to-RAM LED
USB USB connectors
TAPI Telephony connector
WUOL Remote Wakeup power connector
NOTE: Before disconnecting a peripheral from the system or removing a component from the system board, disconnect the system
power cord and verify that the standby power LED on the system board is off. For the location of this LED, see
Figure 25 .
CAUTION: Before you remove the computer cover, see " Precautionary Measures "
1 Securing clips (2)
1 Securing clips (2)
2 Notches (2)