Dell Precision 220 - Manual (Page 21)

12. Slide the system board toward the front of the chassis until it stops.
13. Carefully raise the front of the system board and lift the board out of the chassis at an angle.
To replace the system board, perform the following steps:
1. Carefully replace the system board in the chassis by performing steps 11 through 13 of the removal process in reverse.
2. Push down near each slot to engage the grounding clip onto its corresponding tab.
3. Push evenly on both sides of the system board as you slide and lock it into position (do not twist the system board).
4. Reinstall the mounting screw.
5. Reinstall all components on the system board by performing steps 4 through 10 of the removal process in reverse.
6. Set the jumpers on the new system board so that they are identical to those on the old board, unless you are installing a microprocessor
upgrade.
7. Replace the computer cover, connect all cables, and restart the system. Run System Setup to ensure that your settings are correct and that
all system board components are correctly reported.
8. Run the Dell Diagnostics.
Back to Contents Page