Modular drive, Removing the modular drive, Replacing the modular drive – Dell Precision M2400 (Mid 2008) User Manual
Page 71
Back to Contents Page
Modular Drive
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
The modular drive supports either a second hard drive, an optical drive, or a an air bay for travel.
Removing the Modular Drive
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Turn your computer upside down.
3.
If your computer has a security screw for the modular drive, remove the security screw.
4.
Push the release latch in to release it.
5.
Use the release latch to slide the drive out of the modular bay.
Replacing the Modular Drive
1.
Slide the drive into the modular bay, and then press the release latch to lock the drive in the bay.
2.
If your computer has a security screw for the modular drive, replace the security screw.
3.
Follow the procedures in
After Working on Your Computer
.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTE:
The security screw on the modular drive is optional and may not be installed on your computer.
1 security screw 2 modular bay
3 modular drive 4 release latch
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTE:
The security screw on the modular drive is optional and may not be installed on your computer.