Dell Precision M2400 (Mid 2008) User Manual
Page 36
1.
Replace the two M2 x 3-mm screws on the right bracket and the two
M2 x 3-mm screws on the left bracket.
2.
Connect the display cable to the connector on the back of the display panel.
3.
Route the display cable around the notch on the display cover and set the display panel in place.
4.
Replace the four M2.5 x 5-mm screws that secure the display panel to the display cover.
5.
Replace the display bezel (see
Replacing the Display Bezel (E6400 and M2400)
).
6.
Replace the display assembly (see
Replacing the Display Assembly (E6400 and M2400)
7.
Replace the hinge covers (see
Replacing the Hinge Covers
).
8.
Replace the bottom of the base assembly (see
Replacing the Bottom of the Base Assembly
).
9.
Follow the procedures in
After Working on Your Computer
.
Removing the Display Panel and Brackets (E6400 ATG)
1.
Follow the instructions in
Before Working on Your Computer
.
2.
Remove the bottom of the base assembly (see
Removing the Bottom of the Base Assembly
).
3.
Remove the hinge covers (see
Removing the Hinge Covers
).
4.
Remove the display assembly (see
Removing the Display Assembly (E6400 ATG)
).
5.
Removing the Display Bezel (E6400 ATG)
6.
Remove the four M2.5 x 5-mm screws from the display panel.
7.
Lift the display panel out of the display cover and lay the display panel flat on your workspace.
8.
Disconnect the display cable. Squeeze the release tabs together, then pull the cable out of the connector.
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTE:
The brackets are labeled "L" (left) and "R" (right).
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1 M2.5 x 5-mm screws (4) 2 display panel
3 display cover
NOTICE:
Touch screen display panels include a second cable (touch screen cable) to attach to a touch screen display panel. For non-touch screen
display panels, leave the touch screen cable taped to the display cover.