Dell Precision M2400 (Mid 2008) - Manual (Page 33)

2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly ).
3. Remove the hinge covers (see Removing the Hinge Covers ).
4. Remove the display assembly (see Removing the Display Assembly (E6400 and M2400) ).
5. Remove the display bezel (see Removing the Display Bezel (E6400 and M2400) ).
6. Remove the four M2.5 x 5-mm screws from the display panel.
7. Lift the display panel out of the display cover and carefully lay the display panel flat on your workspace. Be careful to avoid damaging the display panel
with the hinges and cables on the display cover.
8. Disconnect the inverter backlight cable from the inverter.
9. Disconnect the display cable. Squeeze the release tabs together, then pull the cable out of the connector.
10. Remove four M2 x 3-mm screws from the right bracket and four M2 x 3- mm screws from the left bracket.
1 M2.5 x 5-mm screws (4) 2 display panel
3 display cover 4 inverter backlight cable
1 underside of display panel 2 display cable
3 connector release tabs 4 display cable connector