Hard drive, Removing the hard drive – Dell Precision M2400 (Mid 2008) User Manual

Page 51

Back to Contents Page

Hard Drive

Dell™ Latitude™ E6400 and E6400 ATG and

Mobile Workstation Precision™ M2400 Service Manual

Removing the Hard Drive

Follow the procedures in

Before Working on Your Computer

Close the display and turn the computer upside down.

Remove the two M3 x 3-mm screws.

Slide the hard drive out of the base assembly.

Remove the M3 x 3-mm screw on the hard drive bezel.

Remove the hard drive bezel.

NOTE:

Dell does not guarantee compatibility or provide support for hard drives obtained from sources other than Dell.

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.

CAUTION:

Do not touch the metal housing of the hard drive if you remove the hard drive from the computer while the drive is hot.

NOTICE:

To prevent data loss, turn off your computer before removing the hard drive. Do not remove the hard drive while the computer is on or

in Sleep state.

NOTICE:

Hard drives are extremely fragile. Exercise care when handling the hard drive.

1 hard drive

2 bottom of base assembly

3 M3 x 3-mm screws (2)