Dell Adaptec U320 SCSI Raid 0 or 1 Controller Card - Manual (Page 18)

Post Display Mode [Auto-sync] Verbose, Silent, Diagnostic Verbose
SCSI Controller INT 13 Support Enabled
Disabled: Scan Bus Disabled: Not Scan Enabled
Domain Validation Enabled, Disabled Enabled
Support Removable Disks Under
INT 13 as Fixed Disks** Disabled,
Boot Only,
All Disks Disabled
BIOS Support for Bootable CD-ROM** Enabled, Disabled Enabled
* Setting is valid only if Multiple LUN Support is enabled.
**Settings are valid only if host adapter BIOS is enabled.
Using SCSISelect Settings
Starting and Exiting SCSISelect
To start SCSISelect:
1. When you turn on or reboot your system, press to access the Configuration Utility when prompted by
the following message:
2. Select the controller to be configured and press .
3. From the Configuration Utility menu, select S
The Controller Configuration and SCSI Configuration menu options are displayed.
To exit SCSISelect, press until a message prompts you to exit. If you changed any controller settings, you are
prompted to save the changes before you exit. Select Yes to exit and reboot the system. Any changes you made in
SCSISelect take effect after the system boots.
Using the SCSISelect Menus
To select an option, use the arrow keys to move the cursor to the option, then press . In some cases, selecting
an option displays another menu. You can return to the previous menu at any time by pressing .
To restore the original SCSISelect default values, press from the main SCSISelect screen.
To toggle the display between color and monochrome modes, press from the main SCSISelect screen.
NOTE: Some monitors do not support the ability to toggle between color and monochrome modes.
SCSI Bus Interface Options