Dell Adaptec U320 SCSI Raid 0 or 1 Controller Card - Manual (Page 17)

SCSI Controller Parity Enabled
Disabled Enabled
SCSI Controller Termination:
Ch. A
Ch. B
Automatic, Disabled
Automatic,
Disabled
Automatic
Automatic
Boot Device Configuration Options—BBS Systems Only:
Select Master SCSI Controller
[Auto-sync] A, B A
Boot SCSI Controller [Auto-sync] A, B A
Boot Device Configuration—Non-BBS Systems Only:
Select Master SCSI Controller
[Auto-sync] A, B A
Boot SCSI Controller [Auto-sync] A, B A
Boot SCSI ID [Auto-sync] 0-15 0
Boot LUN Number* [Auto-sync] 0-7 0
SCSI Device Configuration Options:
Sync Transfer Rate (MB/sec) 320, 160, 80.0, 66.6, 40.0, 33.3, 20.0,
10.0, ASYN 320
Packetized Yes, No Yes
(Enabled)
QAS Yes, No No
(Disabled)
Initiate Wide Negotiation Yes, No Yes
(Enabled)
Enable Disconnection Yes, No Yes
(Enabled)
Send Start Unit Command Yes, No Yes
(Enabled)
BIOS Multiple LUN Support* Yes, No No
(Disabled)
Include in BIOS Scan** Yes, No Yes
(Enabled)
Advanced Configuration:
Reset SCSI Bus at IC Initialization Enabled, Disabled Enabled
Display Messages during BIOS Initialization
[Auto-sync] Enabled, Disabled Enabled
Extended INT 13 Translation for
DOS Drives > 1 GB Enabled, Disabled Enabled