Dell Vostro 1200 (Early 2009) User Manual
Page 25
Back to Contents Page
Memory
Dell™ Vostro™ 1200 Service Manual
You can increase your computer memory by installing memory modules on the system board. Install only memory modules that are intended for your computer.
Replacing the Memory Module
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
On the bottom of the computer, remove the one M2.5x5-mm screw and nine M2.5x8-mm screws.
4.
Insert a plastic scribe into the notch on the component cover, and lift to remove the cover.
5.
If you are replacing a memory module, remove the existing module:
a.
Use your fingertips to carefully spread the securing clips apart on each end of the memory module connector until the module pops up.
b.
Remove the module from the connector.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
1
M2.5x8-mm screws (9)
2
M2.5x5-mm screw
1
plastic scribe
2
component cover
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.