Dell S320wi Projector User Manual
Page 58

•16:9 — The input source scales to fit the width of the screen to project a
16:9 screen image.
•4:3 — The input source scales to fit the screen and projects a 4:3 image.
Z
OOM
—Press
and
to zoom and view the image.
Adjust the image scale by pressing
or
and press
to view on your remote control
only.
Z
OOM
N
AVIGATION
—Press
to activate the Zoom
Navigation menu.
Use
to navigate the projection screen.
3D D
ISPLAY
—Select On to start the 3D display function (default is Off).
NOTE:
1. When you want to create a 3D experience, you will need a few other
components including:
a Computer/Laptop with a 120 Hz signal output quad-buffered
graphics card.
b "Active" 3D glasses with DLP Link™.
c 3D content. See "Note 4".
d 3D Player. (Example: Stereoscopic Player...)
2. Enable the 3D function when it satisfies any of the below-mentioned
conditions:
a Computer/Laptop with graphics card, capable of outputting at
120 Hz signal via VGA or HDMI cable.
b Input a suite of 3D content via Video and S-Video.
3. "3D Display" selection will only be enabled in the "Display Settings of
the Advanced Settings" menu when the projector detects either of
the inputs mentioned above.
4. 3D support and refresh rate are as below:
a VGA/HDMI 1280 x 720, 1024 x 768, and 800 x 600 at 120 Hz
b Composite/S-Video at 60 Hz
c Component 480i and 576i
5. The recommended VGA signal for laptop is Single-mode output
(Dual mode is not recommended).
Using Your Projector
58