Dell PowerVault 124T - Manual (Page 67)

Troubleshooting: Dell PowerVault 124T DLT VS160 Autoloader User's Guide
file:///T|/htdocs/stor-sys/124T/en/124tvs16/trouble.htm[12/5/2012 10:26:08 AM]
Drive TAflag[34]
Download Fail
TapeAlert Log Entry:
0000000040000000
because you have tried to use the
incorrect firmware for this tape drive.
failed. try again.
Drive TAflag[35]
Drive Humidity
TapeAlert Log Entry:
0000000020000000
Environmental conditions inside the
tape drive are outside the specified
humidity range.
Drive humidity limits
exceeded.
Drive TAflag[36]
Drive Temperature
TapeAlert Log Entry:
0000000010000000
Environmental conditions inside the
tape drive are outside the specified
temperature range.
Cooling problem.
Drive TAflag[37]
Drive Voltage
TapeAlert Log Entry:
0000000008000000
The voltage supply to the tape drive
is outside the specified range.
Drive voltage limits
exceeded.
Drive TAflag[38]
Predictive Failure
TapeAlert Log Entry:
0000000004000000
A hardware failure of the tape drive
is predicted.
Predictive failure of drive
hardware.
Drive TAflag[39]
Diagnostics Required
TapeAlert Log Entry:
0000000002000000
The tape drive may have a hardware
fault
The drive may have a
hardware fault that may
be identified by extended
diagnostics (i.e., SEND
DIAGNOSTIC command).
Run extended diagnostics
to verify and diagnose the
problem.
Check the tape drive user's
manual for device specific
instructions on running
extended diagnostic tests.
Drive TAflag[50] Lost
Statistics
TapeAlert Log Entry:
0000000000004000
Media statistics have been lost at
some time in the past.
Drive or library powered
on with tape loaded Clean drive.
Retry operation.
Drive TAflag[51]
Tape Directory
Invalid at Unload
TapeAlert Log Entry:
0000000000002000
The tape directory on the tape
cartridge just unloaded has been
corrupted. File search performance
will be degraded.
Error preventing the tape
directory being updated
on unload.
The tape directory can be rebuilt
by reading all the data.
Drive TAflag[52]
Tape System Area
Write Failure
TapeAlert Log Entry:
The tape just unloaded could not
write its system area successfully.
Write errors while writing
the system area on
unload.
Copy data to another tape
cartridge.
Discard the old cartridge.