Dell PowerEdge R510 - Manual (Page 70)

70
Using the System Setup Program and UEFI Boot Manager
Embedded Server Management Screen
NOTE:
This section is applicable to systems with hot-swappable hard drives only.
Serial Port Address
(Serial Device 1=COM1,
Serial Device 2=COM2
default) Sets the serial port addresses for the two serial devices.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
External Serial Connector
(Serial Device1 default) Specifies whether Serial Device 1, Serial Device 2,
or Remote Access Device has access to the
external serial connector.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL,
configure the same port address for console redirection
and the serial device.
Failsafe Baud Rate
(115200 default) Displays the failsafe baud rate used for console
redirection. BIOS attempts to determine the baud rate
automatically. This failsafe baud rate is used only if the
attempt fails. This rate should not be adjusted.
Remote Terminal Type
(VT100/VT220 default) Sets the remote console terminal type, either
VT100/VT220 or ANSI.
Redirection After Boot
(Enabled default) Enables or disables BIOS console redirection when the
operating system is loaded.
Option Description
Front Panel LCD
Options Options are User Defined String, Model Number, or None.
If the LCD Home display is set to anything other than User
Defined String, Model Number, or None, this option in BIOS
will display Advanced. You will not be able to edit this setting in
BIOS until it is set back to User Defined String, Model Number,
or None through another LCD configuration utility (such as the
optional BMC or iDRAC6 Configuration Utility or LCD panel
menu).
User-Defined
LCD String You can enter a name or other identifier for the system, to be
displayed on the LCD module screen.
Option Description
book.book Page 70 Friday, November 20, 2009 2:56 PM