Dell PowerEdge C5230 - Manual (Page 33)

31
Obtain IP Address
automatically
This option is to dynamically configure IPv4 address
using DHCP (Dynamic Host Configuration Protocol).
IPv4 Address, Subnet
Mask, and Default
Gateway
These fields are for specifying the static IPv4 address,
Subnet Mask and Default Gateway to be configured to
the device.
NOTE:
• IP Address made of 4 numbers separated by dots as in
"xxx.xxx.xxx.xxx".
• Each Number ranges from 0 to 255.
• First Number must not be 0.
IPv6 Configuration This option lists the following IPv6 configuration
settings.
IPv6 Settings This option is to enable the IPv6 settings in the device.
Obtain an IPv6 address
automatically
This option is to dynamically configure IPv6 address
using DHCP (Dynamic Host Configuration Protocol).
IPv6 Address To specify a static IPv6 address to be configured to the
device. Eg: 2004::2010.
NOTE: When IPv6 Enable and setting DHCP mode, IPv6
address will be assigned of different address each time.
Subnet Prefix length To specify the subnet prefix length for the IPv6
settings.
NOTE: Value ranges from 0 to 128.
Default Gateway Specify v6 default gateway for the IPv6 settings.
VLAN Configuration It lists the VLAN configuration settings.
VLAN Settings To enable/disable the VLAN support for selected
interface.
VLAN ID The Identification for VLAN configuration.
• Value ranges from 2 to 4094 (0, 1 for AMI and 4095
reserved).
Table 1-16. Network Settings
Item Description