Dell PowerEdge 1500SC - Manual (Page 42)

17. Hook the end of the clip without the heat-sink latch to the tab on the edge of the socket.
18. Align the hole in the heat-sink securing clip with the tab on the edge of the socket, and push the heat-sink securing clip handle until it snaps into place
next to the heat-sink.
19. If you are adding a second microprocessor, install the VRM in the VRM_CONN socket making sure that the latches engage (see Figure 6 -16 ).
Figure 6-16. Installing the VRM
20. Reinstall the microprocessor and memory module cooling shrouds (see " Installing the Microprocessor and Memory Module Cooling Shrouds ").
21. Reinstall the system's right-side cover.
22. Replace the front bezel.
23. Reconnect your system and peripherals to their power sources, and turn on system.
24. Press to enter the System Setup program, and check that the PROCESSOR 1 and PROCESSOR 2 categories match the new system
configuration.
See the system User's Guide for instructions.
25. As the system boots, it detects the presence of the new processor and automatically changes the system configuration information in the System Setup
program. If you installed a second microprocessor, the following message is displayed:
Two 1.13 GHZ Processors, Processor Bus: 133 MHz, L2 cache 512 KB Advanced
If only one processor is installed, the following message is displayed:
One 1.13 GHz Processor, Processor Bus: 133 MHz, L2 cache 512 KB Advanced
ALERT! Bezel was previously removed.
26. Enter the System Setup program, and confirm that the top line in the system data area correctly identifies the installed processor(s). See "Using the
System Setup Program" in your User's Guide.
27. While in the System Setup program, reset the chassis intrusion detector.
NOTE: After you remove and replace the front bezel, the chassis intrusion detector causes the following message to display at the next system
start-up: