Performing a one-time boot – Dell Latitude C540 User Manual
Page 114

Internal HDD
CD/DVD/CD-RW drive
During the boot routine, the computer starts at the top of the list and scans each enabled device for the
operating system startup files. When the computer finds the files, it stops searching and starts the operating
system.
To control the boot sequence, you can select (highlight) devices using the
and
keys and then
enable or disable them or change their order in the list.
To enable or disable a device, highlight the item and press
. Enabled items appear
white and display a small triangle to the left; disabled items appear blue or dimmed without a triangle.
To reorder a device in the list, highlight the device and then press
or
(not case-sensitive)
to move the highlighted device up or down.
Boot sequence changes take effect as soon as you save the changes and exit the system setup program.
Performing a One-Time Boot
You can set a one-time-only boot sequence without going into the system setup program. (You can also use
this procedure to boot to the Dell Diagnostics on the Diagnostics Utility partition on your hard drive.)
Turn off the computer.
1.
If the computer is docked, undock it.
2.
Connect the computer to an electrical outlet.
3.
Turn on the computer. When the Dell® logo appears, press
immediately.
4.
If you wait too long and the Windows logo appears, continue to wait until you see the Windows
desktop. Then shut down your computer and try again.
When the boot device list appears, highlight the device from which you want to boot and press
.
5.
The computer boots to the selected device.
The next time you reboot the computer, the normal boot order is restored.