Dell PowerEdge M910 - Manual (Page 47)

About Your System 47
Resynchronizing the Server List at the Remote Client Workstation
Once the iKVM switch is connected, the blades appear in OSCAR. You now
need to resynchronize the servers on any remote workstation to ensure that
the blades are available to any remote users connected to the console switch
through the Remote Console Switch software.
NOTE: This procedure only resynchronizes one remote client workstation. With
multiple client workstations, save the resynchronized local database and load it into
the other client workstations to ensure consistency.
To resynchronize the server listing:
1 Click Resync in the Server category of the Management Panel (MP).
The Resync Wizard launches.
2 Click Next.
A warning message displays indicating that the database is updated to
match the current configuration of the console switch. Your current local
database names may be overridden with the switch names. To include
unpowered SIPs in the resynchronization, click to enable the Include
Offline SIPs check-box.
3 Click Next.
A Polling Remote Console Switch message box appears with a progress
bar indicating that the switch information is being retrieved.
4 If no changes were detected in the appliance, a completion dialog box
appears with this information.
If server changes were detected, then the
Detected Changes dialog box is
displayed. Click Next to update the database.
5 If a cascade switch was detected, the Enter Cascade Switch Information
dialog box appears. Select the type of switch connected to the appliance
from the drop-down list. If the type you are looking for is not available, you
can add it by clicking Add.
6 Click Next. The completion dialog box appears.
7 Click Finish to exit.
8 Start up the analog switch and the system.