Dell PowerEdge M910 - Manual (Page 266)

266 Installing Blade Components
Figure 3-55. Replacing the NVRAM Backup Battery
6 If you removed the system board to replace the battery, reinstall the board
now. See "Blade System Board" on page 276.
7 Close the blade. See "Closing the Blade" on page 161.
8 Install the blade. See "Installing a Blade" on page 158.
9 Enter the System Setup program to confirm that the battery is operating
properly. See "Using the System Setup Program" in your User's Guide.
10 Enter the correct time and date in the System Setup program's Time and
Date fields.
11 Exit the System Setup program.
12 To test the newly installed battery, remove the blade for at least an hour.
13 After an hour, reinstall the blade.
14 Enter the System Setup program and if the time and date are still
incorrect, see "Getting Help" on page 361 for instructions about obtaining
technical assistance.
1 "+" side of battery 2 battery connector
1
2