Dell PowerEdge M910 - Manual (Page 224)

224 Installing Blade Components
PowerEdge M915, M910, M710, M710HD, M610, and M610x
In these blades, the SD card is an unmanaged persistent storage card. A
hypervisor may be installed using this card.
NOTE: For PowerEdge M915, M910, and M710HD, the iDRAC6 vFLASH card can be
set to IDSDM function along with the SD card by setting the Redundancy option to
Mirror mode in the Integrated Devices screen of system setup. When the IDSDM
function is enabled, the vFlash functionality of the iDRAC6 vFlash card gets
disabled.
NOTE: In IDSDM (PowerEdge M915, M910, and M710HD only), the SD card in the
lower card slot is the primary card (SD1) and the SD card in upper card slot is the
secondary card (SD2).
1 Remove the blade. See "Removing a Blade" on page 155.
2 Install the SD card in the lower card slot. See Figure 3-27.
3 Install the blade. See "Installing a Blade" on page 158.
Figure 3-27. Installing and Removing an SD Card (PowerEdge M915, M910, M710,
M710HD, M610, and M610x)
1 SD card in lower card slot 2 iDRAC6 Enterprise card
2
1
2