Dell Acceleration Appliances for Databases - Manual (Page 45)

10. Click OK to exit each dialog, until prompted to restart the system.
11. If you are running in standalone mode, click Yes to reboot, and then skip ahead to
Discovering Multipaths below.
12. If you are running in HA mode, click No at the reboot prompt, as there are still additional
steps to do.
13. Use
regedit
to edit the Registry with the following changes:
HKLM\SYSTEM\CurrentControlSet\services
\Disk\TimeOutValue = 60 secs
\mpio\Parameters\UseCustomPathRecoveryInterval = 1
If you are using Fibre Channel, use the 30-second interval shown below; if you are using
iSCSI, set the interval to 5:
\mpio\Parameters\PathRecoveryInterval = 30 secs
14. For the QLogic HBA (Fibre Channel), make the following changes in the driver, using the
QLogic CLI or GUI in Windows:
QLogic Port Link/Down Timeout = 15 secs
QLogic Port Retry/Down Timeout = 15 secs
Or if you are using Emulex drivers with Fibre Channel, make the following changes:
Emulex LinkTimeout = 15 secs
Emulex NodeTimeout = 60 secs
15. Restart the Windows system.
38