Dell Acceleration Appliances for Databases - Manual (Page 18)

4. Select “Statically assigned IP Address” as shown above.
5. Type the IP address and subnet mask for your network, using the screen above as a guide.
6. Select OK.
7. Click Next to return to the Network Settings – Overview screen.
CONFIGURING ADDITIONAL DEVICES
The process for configuring additional network devices is essentially the same as what was done for
the management port:
1. Select the next unconfigured device.
2. Complete the fields in the Network Card Setup – Address screen as described in the previous
section.
3. Click Next to return to the Network Configuration Overview screen.
Cluster Interconnect Guidelines
• It is strongly recommended to use well-known static IP addresses for the cluster
interconnect, such as 192.168.1.1 and 192.168.2.1 for one node, and 192.168.1.2 and
192.168.2.2 for the other.
• Ensure that the IP addresses are correct for HA connectivity.
• Ensure that two NIC ports have been configured, one for each HA node.
11