Cisco 2940 - Manual (Page 38)

2-8
Catalyst 2940 Switch Hardware Installation Guide
OL-6157-01
Chapter 2 Installation
Installing the Switch
Figure 2-3 Installing the Mounting Screws Under a Desk
Step 3 Peel the adhesive strip off the bottom of the screw template, and attach it to the underside of the desk.
Step 4 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2 inch (12.7 mm) hole in the two screw
template slots.
Step 5 Insert three screws in the slots on the screw template, and tighten until they touch the top of the screw
template.
Step 6 Remove the screw template from underneath the desk.
1 Desktop 4 Adhesive
2 Screw template 5 Wall
3 Screws
1
4
5
2
3
3
89857