Compaq EP Series - Manual (Page 88)

Compaq Deskpro EP Series of Personal Computers 4-45
4.21 Fan Assembly
1. Prepare the computer for disassembly (Section 4.2).
WARNING: Power is continuous to the system board and power supply even when the power
switch is turned off. To prevent damage to the unit, disconnect the power cord from the power
source or the unit before beginning disassembly procedures.
2. Lay the computer down on its large base for greater stability.
3. Remove the access panel (Section 4.6).
4. Disconnect the fan power cable 1 from the system board.
5. Remove the 4 screws 2 that secure the fan to the chassis.
6. Remove the fan from the chassis 3.
7. Pull on the two push-pins that secure the fan grill to remove it from the fan.
Removing the Fan
To install the fan assembly, reverse the above procedure.
✎
Use the fan on Pentium II units 450/100 and above and on Pentium III units
450/100 and above.