Baumer BA Scatec2 - Manual (Page 2)

Manual SCATEC-2 3 Baumer Electric AG
Version 2011-05 www.baumer.com Frauenfeld, Switzerland
0 Table of Contents
1. Safety information and Certifications
2. Introduction
3. Principle of operation
4. Part identification
5. Terms and definitions
6. Signal sequence
7. Installation
8. Adjustments
9. Instructions for use
10. Specifications
11. Accessories
12. Maintenance
13. Troubleshooting
14. Varying data for customized FLDK 110x10/xxxxxx
FLDK 110x10/xxxxxx
Check section 14 for data
and information varying
from the standard manual !
Manual SCATEC-2 4 Baumer Electric AG
Version 2011-05 www.baumer.com Frauenfeld, Switzerland
1 Safety information and Certifications
The laser diode installed in the SCATEC-2 emits visible red light.
This laser belongs to the Class 2 laser standard specified by the
IEC 60825-1 / 2007.
Avoid looking directly into the beam for long periods. Brief
irradiation of the eye (0.25 sec) that can occur during an
accidental glance is not regarded to be dangerous.
However, the laser should not be aimed deliberately at people. The
laser beam should also be blocked at the end of its intended path.
Scatec-2 complies with the following safety standards:
Complies with 21CFR 1040.10 and 1040.11 except for deviations
pursuant to laser notice No.50, dated June 24, 2007