Jeppesen Marine Workboat Navigator 1.3 - Manual (Page 51)

2
-
Installation
47
5
-
Special
Install
5 - Special Installations
Fleet Deployment
Fleet Deployment means installing Workboat Navigator on multiple computers and
boats. Workboat Navigator is designed to allow rapid deployment to multiple boats
and locations by completing the following steps on each computer:
Prepare the Source Image
Create the source image. The source image is the operating system environment
with Workboat Navigator included. For the Workboat Navigator installation
procedure, see steps 1 through 3 in “Chapter 2 - Installation” of this guide.
Configure the Target Computers
Create a snapshot of the source image that will be will be copied to the target
computers.
Copy, or download, the snapshot image onto each of the target computers.
Run C- Map User Setup
Open Start | Programs | Jeppesen Marine | Support Tools | C-Map User
Setup. A message appears asking you to insert an eToken.
Insert the boat’s eToken into a USB port and wait for the red light on the eToken
to stop flashing. Setup may not work properly if you start it before the red light
stops flashing.
Click Yes. A message appears asking if you want to re-initialize Workboat
Navigator.
Click Yes. A message appears warning that you will lose all C-Map licenses.
Click Yes. A message appears noting that user setup was successful.
Click OK to finish.
1.
2.
1.
2.
3.
4.
5.
6.
5 - Special Installations