Dogtra 2500B Series - Manual (Page 18)

32
TESTING
NOTE : The test light may not be visible if the
intensity level is set below level ten.
7. To make sure that your beeper is working
properly, press the Locate button once with the
horn portion facing away from you (or place
your hand over the horn). The sound may be
extremely loud and may cause discomfort to
your ears. If you do hear an audible beeper
sound, your location button is in working order.
8. Press the Mode button once; you should hear
2 rapid beeps. This will put you into the
Run/Point Mode. Keep the receiver/collar
steady to mimic your dog at a standstill point.
Wait for a moment until you hear a double beep
in 2-second intervals. You may proceed to the
next step if the double beep occurs.
9. Press the Mode button a second time; you
should hear 1 rapid beep. This will put you into
the Point-Only Mode. Once again, keep your
receiver/collar steady and wait for a moment
until the collar emits a double beep every 2
seconds. If it is audible, move onto the next
step.
10. Press the Mode button a third time; you should
hear 3 rapid beeps. This mode will turn off
your beeper and remain silent.
33
TESTING
NOTE 1 : The sound that the beeper will emit
will vary depending on your selection with the
(High/Low) toggle switch. The two-dog model:
Dogtra 2502 T&B has a fixed beeper sound
based on the color of the collar.
NOTE 2 : When using the Run/Point mode or
the Point-Only mode, the beeper volume level
reverts back to the volume level that was last
used.
NOTE 3 : In the Run/Point or Point-Only mode
the tone can be changed by holding down the
“Locate” button and then pressing the
“Mode” button when the High/Low toggle
switch is in the desired position.
The unit must be activated and in the
Run/Point or Point-Only mode first.
NOTE 4 : In the Run/Point or Point-Only mode
it is still possible to use electrical stimulation.
* To make sure that your Beeper Volume is in
working condition, please refer to page 23 for
further testing instructions.