Dogtra 2500B Series - Manual (Page 12)

20
BUTTON FUNCTION
“Constant” Button
Pressing the “Constant” button gives
continuous stimulation as long as the button is
pushed, for up to 12 seconds. If the button is not
released after 12 seconds, the stimulation will
automatically turn off as a safety feature. The
collar will be ready to be reactivated once the
button has been released.
“Locate” Button
The “Locate” button is located on the left
side. It causes the collar’s beeper horn to emit a
series of beeps when pushed and it gives you
the ability to keep track of your dog’s location.
On one-dog models, the beeper can be adjusted
between high and low tones. NOTE: The
high/low tone is not an option on two dog units.
On two-dog models, the Green collar emits
the high tone and the Orange collar the low tone
automatically.
“Mode” Button
Your Dogtra 2500T&B has three different
modes. Locate, Run/Point, and Point-Only. The
“LOCATE” mode can be activated at any time,
even when another mode is set, by pressing the
21
BUTTON FUNCTION
top orange button labeled “LOCATE” on the
left side of the transmitter. To set the beeper
unit to Run/Point mode, press the orange
“MODE” button. This button is located on the
left side of the transmitter, under the
“LOCATE” button.
When you press the “MODE” button the
first time, the collar will beep twice. The
beeper unit will always start in Run/Point
mode. It is now in Run/Point mode. The beeper
will sound every 7 seconds while the dog is
running, and every 2 seconds when the dog is
gone on point or become stationary.
The second time you push the “MODE”
button, it will beep once, remain silent while
the dog is running and beep every 2 seconds
when the dog is on point or stationary.
To turn the beeper unit off, press the
MODE button a third time. The unit will emit
three rapid beeps, and the beeper will turn off.
The Locate mode can still be used!
When the toggle switch is set on Low tone,
the beeper will emit a double beep when it is in
Run/Point mode or Point-only mode. If the
toggle switch is set on the High tone, a single
beep will sound when using Run/Point or
Point-Only mode.