Dogtra 2500B Series - Manual (Page 16)

28
DESCRIPTION OF COLLAR / RECEIVER PARTS
Receiver Battery Charging Receptacle and
Rubber Plug
On the inside of the collar receiver, next to
the collar strap, is a battery-charging
receptacle with a rubber plug.
The unit will be fully waterproof with
or without the rubber plug. If the dog was
in salt-water, be sure to rinse the receiver
and charging port with clean water, and let
air dry.
29
BATTERY CHARGER
The battery charger and charging cables
allow you to charge both the transmitter and
receiver at the same time. The battery charger is
designed for a 120-volt wall outlet. (European
230-volt AC chargers and 10-volt car charger for
Lithium-Polymer batteries are also available.)
To use the battery charger for the two-dog
unit, combine both sets of battery charging
(splitter) cables as shown. This enables you to
charge the transmitter and both receivers at the
same time.
NOTE : Only use Dogtra-approved
Lithium-Polymer Battery Chargers for your
Dogtra e-collar. This will prevent any damage
that can be incurred from attempting to use a
different charger.
BATTERY CHARGER
Charging Cable
120 volt
Charger
Wall Outlet
Two-dog unit only