CTEK Z4300U SkyRouter - Manual (Page 29)

22 September 2009
26
Transmit Timer – The user may define a timeout value that will cause any buffered characters to be sent.
Maximum Block Size – The user may define a block size threshold that will cause buffered characters to be sent.
Strip Telnet Line Feed – If selected, line feeds following carriage returns will be deleted from inbound and outbound data
streams.
Inactivity Timer – The user may choose to configure the PAD to terminate a connection if no inbound or outbound data
traffic occurs for a defined period of time.
Please note: Any Data Management Parameter may be disabled by setting its value to zero.
TCP PAD COMMAND DETAIL – The following is a summary of supported AT commands. Although all commands are
shown in upper case, this is not a requirement. Commands may be either upper or lower case. Please note that all
unsupported commands will return a standard OK response for compatibility.
Dial Command – The dial command is used to establish a TCP connection. The following is a summary of all supported
forms of the dial command:
In the following cases, both the IP address and port number are provided as parameters:
ATD Address Port
ATDAddress Port
ATDT Address Port
ATDTAddress Port
ATDP Address Port
ATDPAddress Port
In the following cases, the port number is retrieved from default Destination 1 of Outbound IP Parameters:
ATD Address
ATDAddress
ATDT Address
ATDTAddress
ATDP Address
ATDPAddress
In the follwoing cases, the IP address is retrieved from default Destination 1 of Outbound IP Parameters:
ATD Port
ATDPort
ATDT Port
ATDTPort
ATDP Port
ATDPPort
In the following case, both the IP address and port number is retrieved from default Destination 1 of Outbound IP
Parameters:
ATD
In the following cases, both the IP address and port number is retrieved from the specified Destination of Outbound IP
Parameters:
ATDS=1
ATDS=2
ATDS=3
ATDS=4