CTEK Z4300U SkyRouter - Manual (Page 19)

22 September 2009
16
Set Relay Output State – Used to set the current state of the relay driver circuit. The relay driver can be activated and
deactivated by changing this setting and pressing update.
Relay Shut Off Timer – The relay driver circuit will revert to its default setting after the number of minutes or seconds
specified by this parameter. The two second setting is useful for resetting end point equipment.
Allow SMS Control of Relay – If Yes is checked the relay driver may be activated by sending an SMS with the command
“R1” and deactivated by sending an SMS with the command of “R0”.
Allow Web Browser Control of Relay – If set to yes a button will appear on the Advertising screen to enable and disable
the relay driver circuit.
Text For Web Link To Relay – This text will appear on the advertising screen next to the relay activation button.
4.1 Status
4.1.1 Wireless Status
The Wireless Status interface provides information on the Z4300 Series router’s wireless network connection, local
operating conditions, and predefined information contained within the radio module. Wireless status information can be
refreshed (updated) in real time using the Refresh button at the bottom of the page. The Wireless Status interface is
display only.
Figure 13