Bio-Rad PowerPac™ Universal Power Supply - Manual (Page 17)

3.3.2 Edit (or View) and Run a Saved Method
This section describes how to edit, view and run a saved method.
Step Procedure Description
1. Set up the power supply Refer to sections 3.1 for instrument setup.
2. Select the programming On the Home screen, press the METHODS
mode soft key to view the method list.
3. Open an existing method Use the up and down arrow keys to select a
method to edit (identified by *) and then press
OPEN to open the Method screen. Press
to run the opened method or go to Step 4
to view and edit the method.
4. Select a step to edit Press the up and down arrow keys to select a
step. An asterisk (*) indicates the selected
step. Press EDIT to view or edit. Note: to edit
the method name, use the up arrow key to
move to the method name and activate the
name field. Use the keypad to change the
name.
5. Set the constant Use the soft keys to select the constant
parameter for the parameter and the keypad to enter its value. If
current step the method is complete skip to Step 9,
otherwise, press the EDIT key. Note that the
non-constant parameter values are listed on
the right side of the screen and the time mode
at the bottom.
ConstV:
Used to run with constant voltage.
ConstA: Used to run with constant current.
ConstW: Used to run with constant power.
11
METHOD LIST
IEF
NATIVE
SDS-PAGE
*
OPEN DELETE NEW
METHOD: SDS-PAGE
S1 100V 00:30 HRS
S2 300V 00:30 HRS
S3 (EMPTY)
*
METHODS DELETE
TIME: 00:30 HRS
S1/2 EDIT CONSTANT
CONSTA CONSTW
2500
500
mA
W
CONST V
100 V
SELECT MODE
MANUAL METHODS