B&G Network Pilot (ACP) - Manual (Page 80)

5 - 11
SETTING THE RUDDER END STOPS
Before the Network PILOT can be used it must know the position of the
rudder end stops.
SETTING THE PORT END STOP
Press SETUP
key, select SET
RDP
Move the
rudder to hard
over port
position.
Press ENTER
to set PORT
end stop, the
display
confirms
setting is
successful.
SETTING THE STARBOARD END STOP
Press SETUP
key, select SET
RDS.
Move the
rudder to hard-
over starboard
position.
Press ENTER
to set STBD
end stop, the
display
confirms
setting is
successful.